Found a plan online for a pretty simple bookshelf but it calls for red oak throughout and that's just not in my budget right now. I'm thinking of swapping it all to 2 pine but the plan has some dadoes for the shelves and i'm…
I've been running a Makita BO5041 for about two years and it's been solid, but my buddy swears by his Bosch ROS20VSC and keeps telling me to switch. Curious if anyone here has used both long enough to have an actual opinion, not…
Built a circle cutting jig for the router and the pivot pin keeps shifting mid cut, especially on bigger diameter circles. I've got it set in a 1/4 inch hole drilled through the base but there's just enough slop that the radius…
Been using my router circle jig and it handles smaller stuff fine but i'm curious what the practical upper limit is before it gets sketchy. Mine pivots off a 1/4 inch pin and the arm is about 18 inches, so theoretically i could…
Started with a plan to make a small relief panel, ended up following a curl in the grain and now i have something that looks more like a wave than a leaf. Not mad about it, but i'm curious if other people let the material lead or…
We're doing our first scroll saw project together and i picked a simple animal shape pattern for her to paint after. My question is what grit should we finish sanding at before she goes to town with the craft paint? Also…
Finishing up a 400sqft composite deck and the hidden fastener clips are running me about $180 more than just face screwing it. Last deck I face screwed and honestly it looked fine after a few years but I keep second guessing…
Been using my card scraper on some cherry and i keep getting these faint parallel lines across the grain even after burnishing a fresh hook. Thought maybe my burnishing angle was off so i tried a few different passes but still…
Finally finished a birdhouse with my 7 year old this weekend and honestly it went better than i expected. Pre drilling everything was the move, no split wood and she could actually drive the screws herself. We used a non toxic…
Been using a clamped straightedge for sheet goods and it works okay but i keep second guessing the setup every single time. Did anyone make their own track or is it just easier to grab one of those Kreg or Makita ones? I built a…
Finally getting around to lighting the underside of my wall cabinet shelf above the bench and wondering if regular LED strip tape is good enough or if i should go with something brighter. The cheap stuff always seems dim once its…
Finally got my drill press set up and when i chuck a bit there's a tiny wobble when it spins. Is a little runout just a fact of life on budget machines or should i be worried about bad bearings? Also noticed it more with longer…
Tried gel stain on a pine cabinet face after pre stain conditioner and still getting some blotchy patches, especially around the knots. Let the conditioner dry the full 2 hours before applying but something still went wrong. Has…
Ive been doing 4 coats of wipe on poly on a walnut side table and im wondering how long folks actually wait between coats in a cool garage. The can says 2-3 hours but at like 55 degrees it still feels tacky at 4. Curious if…
been running my shapeoko for about 6 months and i just noticed my pocket depths are off by maybe 0.4mm across the bed. figuring its time to resurface the spoilboard again but curious how often you all redo yours... every few…
Picked up a nice 8/4 walnut slab last spring and stickered it in the garage thinking i was being patient. Came back after a hot stretch and theres a check running almost a third of the way down. Did i skip sealing the end grain…
Been playing with the camber on my no 4 iron and i think i went a touch heavy, leaves faint tracks on wider panels unless i really feather the passes. Curious what others settle on for a smoother, i've heard anything from a…