Been using my router circle jig and it handles smaller stuff fine but i'm curious what the practical upper limit is before it gets sketchy. Mine pivots off a 1/4 inch pin and the arm is about 18 inches, so theoretically i could cut up to a 36 inch diameter circle but at that size the router feels hard to control. Anyone pushed theirs past 30 inches and what did you do to keep it stable?
past 30 inches i'd take multiple shallow passes instead of one deep cut, router wanders bad if you're fighting resistance on a big arc. also clamp a sacrificial piece under the pivot so it doesn't rock mid cut.
Sign in to join this discussion.
Sign in to reply