Forum/Techniques & Joinery/Card scraper keeps leaving faint lines, what am I missing

Card scraper keeps leaving faint lines, what am I missing

#technique#tools
handtoolblair3 replies1 likes
Original Post
Apr 25, 2026

Been using my card scraper on some cherry and i keep getting these faint parallel lines across the grain even after burnishing a fresh hook. Thought maybe my burnishing angle was off so i tried a few different passes but still getting them. Is this a flatness issue on the scraper itself or is my technique just not there yet?

Apr 25, 2026

Flatness is my first guess, even a slight hollow or twist across the face will leave those lines because only the edges are cutting. Try laying it on a flat reference and checking with a light behind it, then flatten on some sandpaper on glass before re-burnishing.

Apr 25, 2026

Share a (close-up) photo of the card scraper and the lines i the wood.

Apr 25, 2026

@Aske Also check if you're pulling the scraper in a consistent direction each pass, because switching angles mid-stroke can leave those marks too. Flatness is the likely culprit though, that glass and sandpaper method works.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedApr 25, 2026
Replies3
Likes1