Built a circle cutting jig for the router and the pivot pin keeps shifting mid cut, especially on bigger diameter circles. I've got it set in a 1/4 inch hole drilled through the base but there's just enough slop that the radius ends up slightly off. Anyone fixed this with a better pin setup or a tighter fit method? Thinking maybe a T nut from below but not sure if that's overkill.
i've never built one of these but i wonder if a snug-fitting brass rod instead of whatever's in there now would help? less slop than a regular pin in a drilled hole, and cheaper than a T nut setup probably.
The T nut idea is actually pretty solid, you can thread in a bolt from below and get a much tighter registration. Brass rod is good too but only if the hole itself is drilled clean, otherwise you're just swapping one slop for another.
Sign in to join this discussion.
Sign in to reply