Forum/Tools & Equipment/Track saw vs miter saw for breaking down sheet goods

Track saw vs miter saw for breaking down sheet goods

#tools#technique
fastcuts2 replies0 likes
Original Post
Apr 26, 2026

Been using my miter saw for pretty much everything but it obviously can't handle full sheets. Thinking about grabbing a track saw to replace my table saw workflow for plywood but not sure if its worth the cost over just clamping a straight edge to a circular saw. Anyone actually use one regularly or is it kind of overkill?

Apr 26, 2026

Honest answer: the clamped straight edge works fine until you're doing it daily and the setup time starts to feel like its own project.

M
mlwoodshopApr 28, 2026

@cncmike wrote:

Honest answer: the clamped straight edge works fine until you're doing it daily and the setup time starts to feel like its own project.

i've been wondering the same thing honestly, i just clamp a straight edge right now and it works but it does take forever to set up each time. is there a big quality difference in the cut edge too or is that more of a blade thing?

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedApr 26, 2026
Replies2
Likes0