Had another close call at the shop today and it reminded me that a lot of people still reach behind or over the blade to clear offcuts while it's spinning. Get a push stick or a scrap piece of wood and knock it clear from the front, blade off, or use a riving knife so offcuts don't pinch and kick. This stuff feels obvious until it isn't.
Riving knife is the one i'd push hardest here. A lot of guys skip it because it takes a few minutes to set up or they swapped it out for a dado and never put it back, but it does so much work passively without you having to think about it. That pinch-and-kick situation is the one that gets people because it can happen before you even register what's happening. And yeah, blade off before you reach anywhere near the back of the cut, no exceptions. A scrap knocker stick costs nothing and keeps your hand six inches further from where you don't want it.
Sign in to join this discussion.
Sign in to reply