Got an older Craftsman contractor saw and the riving knife from a newer model supposedly fits but I can't find anyone who's actually confirmed it. Running without one makes me genuinely uncomfortable, splitter and pawls just aren't the same thing. Anyone swapped one of these out on a pre-2010 model?
I don't have direct experience swapping riving knives on that specific Craftsman but the model number stamped on the trunnion casting usually matters more than the year, might be worth cross referencing on the OWWM forums where the old iron crowd hangs out.
Do you have the model number handy? That's probably the fastest way to get a real answer.
@budgetbench wrote:
Do you have the model number handy? That's probably the fastest way to get a real answer.
Model number is gonna be the key here, and OWWM is genuinely the best place for old Craftsman iron, those folks have seen every variant. Also worth checking if the blade thickness matches since riving knives are spec'd pretty close to the kerf.
Sign in to join this discussion.
Sign in to reply