Forum/Tools & Equipment/Hold down method for curved parts on the CNC

Hold down method for curved parts on the CNC

#technique#tools#help
cncmike1 replies0 likes
Original Post
Apr 29, 2026

Been trying to cut some curved cabinet parts and the blue tape plus CA glue method isn't holding great on pieces with a lot of inside corners. Thinking it's a spoilboard flatness issue but not totally sure. Anyone using a different strategy for odd shaped stock that isn't a full vacuum setup?

Apr 29, 2026

Not a CNC guy myself but i've seen people mention hot glue as a quick backup when tape/CA fails on weird shapes, basically a few dabs around the perimeter and you can pop it off with a flush scraper after. Might be worth a try before you go chasing the spoilboard flatness.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedApr 29, 2026
Replies1
Likes0