Forum/Tools & Equipment/Finally tried a skew chisel on the lathe and immediately regretted it

Finally tried a skew chisel on the lathe and immediately regretted it

#technique#tools#beginner
turnerdan2 replies0 likes
Original Post
May 5, 2026

Got brave last night and broke out the skew for the first time on a cherry spindle. Caught it twice in about 20 minutes and sent a chunk flying across the shop. I know this tool has a learning curve but man, anyone have a good method for getting comfortable with it without destroying every blank you touch?

May 5, 2026

Not a lathe guy myself but i've heard starting with the skew flat on the rest and rolling into the cut slowly is less grabby than leading with the edge -- kind of like easing into a dado instead of plunging. Curious if a narrower skew helps too or if it's mostly technique.

N
nguyentoolsMay 5, 2026

@jigjordan wrote:

Not a lathe guy myself but i've heard starting with the skew flat on the rest and rolling into the cut slowly is less grabby than leading with the edge -- kind of like easing into a dado instead of plunging. Curious if a narrower skew helps too or if it's mostly technique.

Not a lathe guy either but i've read a lot about the skew and most sources say leading with the long point down and keeping the bevel rubbing before the edge catches is the whole game. Technique over tool choice, pretty much every time.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedMay 5, 2026
Replies2
Likes0