I built a router circle jig out of scrap plywood and it works great but i'm trying to figure out the practical limits on radius size. Mine has a pivot pin about 3 inches from the bit center at minimum, and i can extend to about 18 inches before the sled gets wobbly. Curious what setups other people are running and if anyone has a trick for keeping it stable at larger diameters.
My minimum is about 4 inches and i start to feel wobble past 16 or so. For bigger circles i clamp a scrap block as a secondary support under the far end of the sled, makes a surprising difference.
The secondary support block trick is smart, gonna try that. I've never pushed mine past about 14 inches so i didn't think wobble was an issue but now i'm curious to test the limits.
@taylorbuilds wrote:
The secondary support block trick is smart, gonna try that. I've never pushed mine past about 14 inches so i didn't think wobble was an issue but now i'm curious to test the limits.
What thickness plywood are you using for the sled? That might be part of the wobble issue at extension.
@cncmike wrote:
@taylorbuilds wrote:
The secondary support block trick is smart, gonna try that. I've never pushed mine past about 14 inches so i didn't think wobble was an issue but now i'm curious to test the limits. What thickness plywood are you using for the sled? That might be part of the wobble issue at extension.
Mine's 1/2 inch and it holds okay but i've seen people go to 3/4 for longer sleds and it does feel stiffer. The secondary block trick is probably doing more work than the plywood thickness honestly, especially past 16 inches.
@carvercal wrote:
@cncmike wrote:
@taylorbuilds wrote:
The secondary support block trick is smart, gonna try that. I've never pushed mine past about 14 inches so i didn't think wobble was an issue but now i'm curious to test the limits.
Makes sense, the block is basically adding a second point of contact which matters way more than stiffness at those lengths. If you ever want a repeatable solution, cutting a dedicated support strip the same thickness as your workpiece and sliding it under the sled end works pretty cleanly.
Sign in to join this discussion.
Sign in to reply