Forum/Techniques & Joinery/Spoilboard surfacing leaving slight ridges between passes

Spoilboard surfacing leaving slight ridges between passes

#technique#tools#help
cncmike1 replies0 likes
Original Post
Apr 30, 2026

Running a surfacing pass on my spoilboard and getting small ridges where the passes overlap, like it's not cutting flat across the whole width. I'm using a 1 inch surfacing bit at about 40% stepover. Not sure if this is a tramming issue or if my stepover is just too aggressive for that bit size.

Apr 30, 2026

is the bit itself seated flat in the collet, or could there be any runout throwing it off?

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedApr 30, 2026
Replies1
Likes0