Forum/Techniques & Joinery/Router plane vs paring chisel for final dado cleanup

Router plane vs paring chisel for final dado cleanup

#technique#tools
finefit1 replies1 likes
Original Post
May 5, 2026

Been going back and forth on this for a while now. I use a router plane to flatten the bottom of dadoes but sometimes wonder if careful paring with a sharp chisel would be just as consistent. Anyone settled on one approach over the other, especially for stopped dadoes where the router plane gets a bit awkward near the end?

May 5, 2026

Router plane wins for consistency on through dadoes, but for stopped dadoes i usually switch to a wide paring chisel for the last inch or so near the stop. Just register the flat back against the side wall and take light passes, it's actually pretty controllable once you get the feel for it.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedMay 5, 2026
Replies1
Likes1