My router plane keeps losing its depth setting partway through a dado, usually right when i'm sneaking up on the final fit. Tried tightening the lock but it still creeps. Not sure if it's the iron collar or something with the casting on my particular plane.
I had the same creep issue on a depth stop and ended up wrapping a couple layers of electrical tape around the collar shaft before locking it down. Adds just enough friction to hold without being a pain to adjust.
@shopcartcasey Electrical tape works but if you want something more permanent, a thin strip of plumber's teflon tape wrapped around the shaft stays put better and is easier to adjust. Either way, lock it down before every final pass, not just at the start.
Which router plane is it, if you don't mind me asking? Some older ones have notoriously soft castings around the collar seat.
@handtoolblair wrote:
Which router plane is it, if you don't mind me asking? Some older ones have notoriously soft castings around the collar seat.
If the lock knob itself is the weak point, a small piece of thin leather under the collar clamp can help too, same friction principle as the tape but a bit more durable. Worth checking if the collar shaft has any wear on it first though, sometimes its just a sloppy fit that no amount of friction will fully fix.
Sign in to join this discussion.
Sign in to reply