Forum/Techniques & Joinery/Feeds and speeds for 1/4 inch upcut in Baltic birch?

Feeds and speeds for 1/4 inch upcut in Baltic birch?

#technique#tools
cncmike1 replies0 likes
Original Post
May 5, 2026

Running a 1/4 inch upcut spiral in 3/4 Baltic birch and getting some nasty fuzz on the top surface, especially on pocket cuts. I'm at 18000 RPM and around 60 ipm feed rate with a 0.1 inch depth per pass. Anyone dialed this in better or am I just expecting too much from upcut?

May 5, 2026

Upcut bits are kinda the culprit there, they pull fibers up on the entry side. A lot of guys drop to 14-16k RPM and bump feed slightly, or just switch to a downcut for the top face if fuzz is a deal breaker.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedMay 5, 2026
Replies1
Likes0