Been using the blue tape and CA glue method for holding down thin plywood on my spoilboard and it works great for small stuff, but anything over like 18 inches tends to lift a corner mid cut and ruins the piece. Running a pretty aggressive upcut bit so that's probably not helping, but even with a downcut it still pulls up. Anyone switch to a different workholding method for bigger sheets without drilling into the spoilboard every run?
For longer pieces i'd switch to actual clamps or vacuum hold down if you have it, but if you're stuck with tape and CA, try running a bead of CA along the full perimeter and hitting it with accelerator so the whole edge bonds at once instead of just spots. Upcut bit is definitely fighting you though, worth swapping to compression if you can.
Sign in to join this discussion.
Sign in to reply