Forum/Project Showcase/Swapping oak for pine in a side table plan, worth it?

Swapping oak for pine in a side table plan, worth it?

#modification#furniture#tips
cutlistavery3 replies0 likes
Original Post
Apr 30, 2026

Found a plan for a small side table I really like but it calls for red oak and that's way out of my budget right now. I've swapped species before on simpler stuff but this one has some narrower rails that I'm a little worried about in pine. Anyone done this kind of swap and had issues with the thinner pieces being too flexible or prone to denting?

Apr 30, 2026

Pine can work but the narrower the rail the more it matters which pine you're using. Eastern white pine is pretty soft and those rails will flex noticeably under any real load, whereas something like southern yellow pine is a lot stiffer and closer to oak in feel. I'd look at the rail dimensions and if anything is under about 3/4 inch thick i'd honestly consider gluing up a slightly thicker blank and dimensioning back down, gives you more material to work with. Denting is real with pine on a piece that sees daily use, though a hard wax finish helps a bit. If the joints are mortise and tenon you should be fine structurally, pocket screws into soft pine rails are where things get wobbly over time.

May 1, 2026

@handtoolblair what are the rail dimensions on the plan, thickness specifically?

C
carvercalMay 1, 2026

@budgetbench wrote:

@handtoolblair what are the rail dimensions on the plan, thickness specifically?

Pine dents easier than most people expect on a piece you actually use daily, that's the real concern more than flex for a side table. if the rails aren't load bearing in a structural sense you're probably fine, but i'd grab SYP over white pine if you can find it.

Sign in to join this discussion.

Sign in to reply

Thread Info

CreatedApr 30, 2026
Replies3
Likes0