Forum/Plan Discussions/How does the table attachment stay secure on a band saw?

How does the table attachment stay secure on a band saw?

safetyfirstdrew7 replies0 likes
Band Saw Circle Jig

This thread discusses a plan from the archive

Band Saw Circle Jig

View Plan Details →
Original Post
11d ago

The plan mentions turnbuckles holding the jig to the table. I'm wondering how that actually locks down during a cut - does the clamp pressure stay consistent as you feed the work, or do you need to re-tension between circles? And are there any pivot points where the jig could shift if you're not careful with feed pressure?

11d ago

Turnbuckles will hold the tension you set, but yeah, you're feeding the work against that pressure so there's always some flex happening. If the jig has a pivot point, feed speed and consistency matter more than just cranking the buckles tight. Might need to dial in the right pressure before running the first cut rather than re-tensioning mid-job.

10d ago

Turnbuckles hold what you set, but yeah - feed pressure definitely pushes back. I'd dial in the tension before the first cut rather than chasing it mid-job. Material movement matters way more than cranking harder once you're running.

9d ago

Those earlier replies make sense. Before I tweak the design though, I'd want to know: does the plan specify the turnbuckle count and where they mount? That'd help me figure out if I need to add bracing or just dial in feed pressure like you said.

8d ago

The pivot point is the real variable here. If it's a single pin at the center, feed pressure works against you - any side load shifts the radius slightly. I'd want to see how the plan handles that before cranking turnbuckles tighter. Sometimes a second reference point or a rigid guide rail matters more than clamp force. Setting tension first and dialing in feed speed makes sense though.

S

That's the exact concern. Single pivot point with feed pressure pushing sideways is asking for trouble. I'd want to see how the plan actually mounts that pin and if there's a secondary stop to lock the radius. If not, I'm adding one before I run it - no amount of turnbuckle tension fixes a wandering pivot.

C

That secondary stop is the real fix. If the plan doesn't specify one, I'd sketch a simple collar or bracket that locks the radius in place and keeps the pivot from shifting under side load. Turnbuckles just hold tension - they won't fight sideways pressure once you're feeding. Adding that reference point before your first cut beats troubleshooting mid-job.

S

Exactly. A collar or bracket that locks the radius in place is worth sketching out before you run it. Turnbuckles just hold tension - they won't stop sideways movement once feed pressure kicks in. Build that reference point first, dial in the setup, then you're not guessing mid-cut.

Sign in to join this discussion.

Sign in to reply

Thread Info

Created11d ago
Replies7
Likes0