I have two nice pieces of walnut that I plan to use to make a side table. Both pieces are variegated in color – mostly dark in the middle and lighter on the outsides. Neither piece is wide enough to use alone for the table top. In fact, I don’t like using single wide boards for table tops for fear of warping. In any event, given the differences in color deciding how to cut and put them together seems tricky. Also, until I actually start cutting I can’t visualize how different combinations of cuts and joining together would look. I hope this makes sense. I would imagine some of you folks have faced this before – any ideas about how to proceed? I can post a picture or two of the two boards if it would help.
Pictures would really help. I'd lay them out a few different ways before cutting - maybe one as a border frame around the other, or cut matching strips from each and alternate them. Seeing the actual color variation would make it way clearer which combo works best.
The picture step is key here. Before cutting, I'd lay both pieces out flat and live with the arrangement for a day or two - walnut's color shifts depending on light angle and it changes your whole layout decision. Once you see them together, the variegation either works for or against certain joint patterns.
Looking for expert custom ADU builders TOADU Builders designs and builds personalized accessory dwelling units with quality craftsmanship, innovative designs, and professional service in Thousand Oaks, CA.
Sign in to join this discussion.
Sign in to reply