I've been using shellac as a barrier coat before wipe on poly for a while now and it's worked great, but on this last piece it's going milky in a couple spots. I let the shellac dry overnight before applying the poly, so I don't think it's a cure time issue. Anyone else run into this, maybe a contamination thing or wrong shellac type?
Milky spots after applying poly over shellac is almost always a moisture issue, not the shellac itself. Even if it dried overnight, if your shop was humid or the surface cooled down before you applied the poly, you can trap condensation under the film. Also worth checking what kind of shellac you used - dewaxed is the safe bet as a barrier coat, the waxed stuff can cause adhesion and clarity problems with poly on top. One other thing: wipe on poly applied too thick in one pass will cloud before it can flash off properly, so if you went a little heavy that could be it too.
The waxed shellac thing is real - i made that mistake once and the poly just sat on top like it was sitting on grease. Double check the label, dewaxed only if you're topcoating with poly.
@jigjordan wrote:
The waxed shellac thing is real - i made that mistake once and the poly just sat on top like it was sitting on grease. Double check the label, dewaxed only if you're topcoating with poly.
I didn't know the waxed vs dewaxed thing mattered that much until just now, so that's actually really useful. If yours is the waxed kind that's probably your culprit before anything else.
Sign in to join this discussion.
Sign in to reply